Gear Finisher - 1st Shift (DSC)

Performs a variety of gear finishing operations, which cannot be performed by machine. Hand grinds and hand finishes all types of gears, splines and sprockets, manufactured in the gear section to required tolerance. Using hand or bench type power tools breaks sharp edges, deburrs, chamfers, forms radii and finishes gears to blueprint specifications or verbal instructions.

Selects proper grinding wheels and abrasive material to properly and adequately hand finish each gear tooth using extreme caution to keep from burning, nicking or marring surfaces. Uses considerable care to remove correct amount of material at the exact locations on each tooth. Makes salvage repairs and corrects inspection rejects in finishing all types of gears, splines and sprockets. May etch, stamp or mark work for identification.

Tools & Equipment Used:

Files, abrasives, band and bench power tools and attachments, etching and marking devices, grinding wheels, measuring instruments and gauges.

Experience & Other Requirements:

One year of machine shop experience or one year of hand finishing of machined parts.

This position requires use of information which is subject to the International Traffic in Arms Regulations (ITAR).  All applicants must be U.S. persons within the meaning of ITAR.  ITAR defines a U.S. person as a U.S. Citizen, U.S. Permanent Resident (i.e. 'Green Card Holder'), Political Asylee, or Refugee.

Textron is an Equal Opportunity Employer (M/F/D/V)