Job Summary

We are seeking a hands-on Electrical Engineer for the development, integration, characterization, and troubleshooting of subsystem-level electrical testers. This role is highly technical and execution-focused, with a strong emphasis on practical hardware engineering.

The ideal candidate should have 4–8 years of recent hands-on experience in designing and building electronics and semi-automated test systems, integrating hardware/software, and debugging complex electrical issues.

Key Responsibilities

Tester Development & Integration

Design, build, and maintain subsystem characterization testers:

Power distribution and protection
Signal conditioning and measurement
Control, interlocks, and safety circuits

Develop custom test hardware (fixtures, wiring harnesses, test jigs)
Integrate testers with:

Mechanical fixtures
Sensors, actuators, power electronics, embedded systems
Lab and production environments

Electrical Characterization & Debugging

Perform subsystem electrical characterization:

Voltage/current measurements
Signal integrity and timing analysis
Noise and grounding

Troubleshoot issues in:

Analog and digital electronics
Power supplies, converters, motor drives
Communication interfaces (I²C, SPI, UART, CAN, Ethernet, USB)

Hands-On Lab Execution

Execute testing in lab environments:

Bring-up of testers and subsystems
Debug under schedule pressure
Support verification and troubleshooting

Use lab equipment:

Oscilloscopes, logic analyzers, DMMs, power analyzers
Environmental and stress testing setups

Required Qualifications

Bachelor’s degree in Electrical/Mechanical Engineering or related field
4–8 years of hands-on experience in:

Test system development
Subsystem-level electrical integration & characterization

Experience in:

Analog & digital circuit design/debugging
Power electronics (low-voltage/high-current systems)

Strong troubleshooting skills using lab tools
Experience across full lifecycle: concept → build → bring-up → support

Strongly Preferred

Embedded subsystems
Motion control systems
Sensor & transducer technologies
Power distribution systems
Communication protocols (CAN, Ethernet, RS-232, RS-485)

Preferred Qualifications

Medical device experience
Familiarity with industry standards
Exposure to PLM tools and change management
EMI/EMC knowledge in harness design

Key Skills

Wire harness design & routing
Electrical schematics interpretation
NX Routing (3D harness design)
Component selection & validation
Strong analytical and communication skills

Learn more about this Employer on their Career Site